- Pet smart GPS locatorSherline CNC Upgrade Kit for Sherline CNC Machines

Title Default Title
Qty:

Description

  • Sherline CNC Upgrade Kit for Sherline CNC Machines
  • Facilitates use with personal computers
  • Includes 4-axis driver and power supply
  • Connects via 25-pin parallel cable
  • Supports Linux/EMC2 with included CDs
  • Provides customizable CNC milling experience

The Sherline CNC Upgrade Kit for Sherline CNC Machines facilitates the use of personal computers and software with Sherline CNC mills. This kit includes a 4-axis driver box, power supply, and three stepper motors, allowing users to connect their own computer via a 25-pin parallel cable. The stepper motors are easily attached to the X, Y, and Z axes of the CNC-ready mill. Once the user's control software is installed, the system is operational. This upgrade kit is ideal for those seeking a customizable CNC milling experience.

  • 1x Driver box with 4 motor cables
  • 1x 3.7 amp, 24-volt power supply with cord
  • 1x 25-pin parallel cable
  • 2x CD set with Linux/EMC2, utilities, and instructions
  • 2x Spare fuse
  • Driver box with four motor cables
  • 3.7 amp, 24-volt power supply with cord
  • 25-pin parallel cable
  • Two CDs with Linux/EMC2, utilities, and instructions
  • Two spare fuses
  • Minimum computer requirements: Processor speed of 800 MHz or faster (Pentium III class or equivalent), RAM of 512 MB (Sherline provides 1 GB), Hard drive of 20 GB or larger, 25-pin parallel port
  • Power supply input: 100-240 VAC, 47-63 Hz, 3A (automatically adapts to incoming voltage)
  • Output: 24 VDC, 4A
  • Parameters: Logic high levels greater than 2 volts, Logic low less than 1/2 volt, Step pulses active low, Step pulses at least 22 microseconds long
  • DB25 pin out: 1 – Input from LinuxCNC, 2 – X Direction, 3 – X Step, 4 – Y Direction, 5 – Y Step, 6 – Z Direction, 7 – Z Step, 8 – A Direction, 9 – A Step, 10 – NC, 11 – Output to LinuxCNC, 12 – Output to LinuxCNC, XYZ home, 13 – NC, 14 – Input from LinuxCNC, C1, 16 – Input from LinuxCNC, C2, 17 – NC, 18-25 – Ground
  • Headers on PC board: H1 – Reduces current to 1/4 after 3 seconds, H2 – Unimplemented, H3 – Removes power from drivers immediately (panic stop), RESET – Holds the drivers in reset condition
  • Motor connectors: 5-pin DIN male, Five to 30 volts (better performance at higher voltage), 2 amp unipolar configuration, 800 steps per revolution (microstepping), equates to 16,000 steps/inch with .050″ pitch leadscrew